Chapter 4
SC-2052
©
National Instruments Corporation
4-3
SC-2052 Connection
Connect your SC-2052 to the DAQ device via an R6850-D1 or a type NB1,
50-pin ribbon cable (for the AT-DIO-32F). Make this connection with the
host computer powered off. Connect one end of the ribbon cable to the
SC-2052 at either connector J1 or J2. Connect the other end to the DAQ
device installed in your computer.
Warning
Do not connect the SC-2052 to a board for which it is not designed. Such
connection can damage the SC-2052 and any or all boards/accessories connected
to the SC-2052 and the host computer. National instruments is
NOT
liable for any
damages resulting from incorrect connections.
To connect your SC-2052 to the signal conditioning accessories, use a type
NB7, 26-pin ribbon cable. This cable connects the SC-2052 to any of the
SC-206
X
Series boards. An 8-channel SSR Series backplane with a
26-conductor ribbon cable is also available for connection to the SC-2052.
For instructions on making these connections to the proper signal
conditioning accessories, refer to
.
Connectors
The SC-2052 has two 50-pin ribbon cable connectors that are connected
pin-by-pin to each other. You can use either of these connectors to attach
the SC-2052 to the DAQ device via a cable. You can daisy-chain the
second connector to other 50-pin accessories.
The SC-2052 also has four 26-pin ribbon cable connectors that you can
connect to the signal conditioning accessories. The digital ports are
compatible with the SC-206
X
Series digital signal conditioners as well as
with the 8-channel SSR Series solid-state relay board.
The SC-2052 has 2-pin screw terminals which are connected to auxiliary
digital input lines and digital output lines of the DAQ device. You can use
these screw terminals to attach these lines to appropriate external circuitry.
Figure 4-2 illustrates the connections between the SC-2052 and the
necessary accessories and devices.
Summary of Contents for SC-2042-RTD
Page 1: ...SC 2042 RTD...