�
3.3
�
and
�
���
= 80 %
�
5
�
and
�
���
= 90 %
Note
You must add 10% to the calculated or measured total power requirement to
account for transient and startup conditions.
Table 22.
Approximate Maximum Power Requirement
Power
Values and Calculations
Maximum P
int
11.36 W
Maximum P
DIO
Total DIO current × 3.3
�
/0.8
Maximum P
5V
Total 5 V current × 5
�
/0.9
Maximum P
3.3V
Total 3.3 V current × 3.3
�
/0.8
Maximum P
USB
Total USB current × 5
�
/0.9
Note
These calculations are intended to approximate the maximum power
requirements for an NI sbRIO device system. For a more accurate estimate of the
power consumption of a specific application, NI recommends that you directly
measure a board running the application in an environment representative of the
intended use case.
Configuring the sbRIO-9607
You can connect the sbRIO-9607 to a host computer or network and configure the startup
options using the RJ-45 Gigabit Ethernet port. If a RIO Mezzanine Card is designed with a
device USB connector, the target can also be configured using the device USB port.
Tip
Refer to the
NI sbRIO-9607 Getting Started Guide
on
configuration instructions and information about connecting to a host computer
using the RJ-45 Gigabit Ethernet port.
Tip
Refer to the
NI sbRIO-9607/9627 RMC Design Guide
on
basic configuration instructions and information about connecting to a host computer
using the device USB port.
NI sbRIO-9607 User Manual
|
© National Instruments
|
43
