Table 2. Device Front Panel Icon Definitions
Refer to the user documentation for required maintenance measures to ensure user
safety and/or preserve the specified EMC performance.
The signal pins of this product's input/output ports can be damaged if subjected to
ESD. To prevent damage, turn off power to the product before connecting cables and
employ industry-standard ESD prevention measures during installation, maintenance,
and operation.
Table 3. PXIe-5606 RF Downconverter Front Panel Connectors
Connector
Use
RF IN
Connects to the analog RF input signal to be measured by the vector signal
analyzer. The maximum RF input is +30 dBm.
Note
The PXIe-5606 downconverter module ships with a DC
block attached to the RF IN connector. To make measurements
below 16 kHz, you must remove the DC block. Refer to
PXIe-5606 RF IN Connector DC Block
information.
IF OUT
Connects to the IF IN connector on the PXIe-5624 module front panel.
This connector is the output terminal for the frequency-translated IF
signal.
LO1 IN
Connects to the LO1 OUT connector on the PXIe-5653 module front
panel.
This connector is the input terminal for the LO1 (3.2 GHz to 8.3 GHz)
source. LO1 IN is an SMA connector with an impedance of 50 Ω
(nominal).
LO2 IN
Connects to the LO2 OUT connector on the PXIe-5653 module front
panel.
This connector is the input terminal for the LO2 (4 GHz) source. LO2 IN
is an SMA connector with an impedance of 50 Ω (nominal).
LO3 IN
Connects to the LO3 OUT connector on the PXIe-5653 module front
panel.
This connector is the input terminal for the LO3 (800 MHz) source. LO3
IN is an SMA connector with an impedance of 50 Ω (nominal).
12
|
ni.com
|
PXIe-5668 Getting Started Guide
