2-8
|
ni.com
Chapter 2
Installation and Configuration
Installing PXI Modules
Complete the following steps to install a module.
1.
Make sure the power switch is in the Off (Standby) position.
2.
Install a module into a chassis slot by first placing the module card edges into the front
module guides (top and bottom), as shown in Figure 2-5. Slide the module to the rear of the
chassis, making sure that the injector/ejector handle is pushed down as shown in Figure 2-3.
3.
When you begin to feel resistance, push up on the injector/ejector handle to fully inject the
module into the chassis frame. Secure the module front panel to the chassis using the
module front-panel mounting screws.
Figure 2-5.
Installing PXI or CompactPCI Modules
1
PXI-1036/PXI-1036DC Chassis
2
Injector/Ejector Rail
3
Injector/Ejector Handle
4
PXI Module
5
NI PXI Controller
5
4
3
1
2
NI PXI-1
036
