Appendix A
Device-Specific Information
A-80
ni.com
•
Two 24-bit counter/timers for TIO
•
A 68-pin I/O connector
Because the NI 6052E devices have no DIP switches, jumpers, or
potentiometers, you can easily configure and calibrate them through
software.
NI PCI/PXI-6052E Block Diagram
Figure A-69 shows a block diagram of the NI PCI/PXI-6052E.
Figure A-69.
NI PCI/PXI-6052E Block Diagram
NI PCI/PXI-6052E Pinout
Figure A-70 shows the NI PCI/PXI-6052E device pinout.
Note
Some hardware accessories may not yet reflect the NI-DAQmx terminal names. If
you are using an E Series device in Traditional NI-DAQ (Legacy), refer to Table 1-5 in
Chapter 1 for the Traditional NI-DAQ (Legacy) signal names.
PCI/PXI Bus
Configuration
Memory
Timing
PFI / Trigger
I/O Connector
6
2
2
RTSI Bus
Digital I/O (8)
16-Bit
Sampling
A/D
Converter
REF
Buffer
Programmable
Gain
Amplifier
–
Calibration
Mux
Mux Mode
Selection
Switches
Voltage
REF
Calibration
DACs
DAC0
DAC1
DAQ - STC
Analog Input
Timing/Control
Analog Output
Timing/Control
Digital I/O
Trigger
Counter/
Timing I/O
RTSI Bus
Interface
DMA/
Interrupt
Request
Bus
Interface
8
8
AI Control
IRQ
DMA
AO Control
Data (16)
Trigger Level
DACs
Analog
Trigger
Circuitry
Data (16)
Trigger
EEPROM
Address/Data
Control
Data (16)
Analog
Input
Control
EEPROM
Control
DMA
Interface
MIO
Interface
DAQ-STC
Bus
Interface
Analog
Output
Control
I/O
Bus
Interface
Address (5)
Analog
Muxes
DAC
FIFO
ADC
FIFO
MITE
Generic
Bus
Interface
PCI
Bus
Interface
+
8
Calibration
DACs
