Chapter 5
Getting Started with Measurement Studio
©
National Instruments Corporation
5-49
Measurement Studio User Manual
5.
To complete the DAQ configuration, select the
N Samples
Acquisition
Mode in the
Timing Settings
section. For more information on
timing, refer to Timing in the
NI-DAQmx Help
.
6.
Next, click the
Run
button in the toolbar near the top of the Edit DAQ
Task dialog box. The test runs automatically. You can run the test in the
DAQ Assistant to test the task and make sure you connected the signal
properly. If necessary, you can modify the settings before any code is
generated.
7.
Click the
Finish
button in the Edit DAQ Task dialog box to complete
the configuration of your DAQ task and to launch the Configure DAQ
Component UI wizard.