1
2
1.
Insert the bus connector for the REM-11100 into the DIN rail.
Caution
Verify that you are using the correct bus connector for the module
width.
2.
Slide the bus connector along the DIN rail until it connects to the preceding bus
connector.
Note
A bus connector will not attach to a preceding bus connector with a
mounted module. Remove the preceding module before installing additional
bus connectors.
3.
Repeat Steps 2 and 3 for additional bus connectors.
Installing the Module
What to Use
•
REM-11100
•
Mounted bus connector
What to Do
Complete the following steps to install the REM-11100 on the DIN rail.
REM-11100 Getting Started Guide
|
© National Instruments
|
5
