MID-7654/7652 Servo Power Motor Drive User Guide
24
ni.com
Accessories Included for Optional Use
Strain-Relief Bar Installation
The strain-relief bar provides strain relief for wiring to the back panel terminals of the MID-7654/7652.
It must be used to provide necessary grounding for CE compliance. Refer to the
section of this guide for more information.
The arms of the strain-relief bar attach between the sides of the MID-7654/7652 and the bottom
mounting plate of the rear guard with the thumb nuts facing upwards, as shown in Figure 23. Refer to
the
section of this guide for more information on removing and replacing the protection
cover from the rear guard. Refer to Figure 23 while following these strain-relief bar installation steps:
1.
Remove the protection cover of the rear guard.
2.
Place the strain-relief bar so it fits within the sides of the bottom mounting plate.
3.
Attach the strain-relief bar to the side panels of the MID-7654/7652 using the provided screws.
4.
Replace the protection cover.
Figure 23.
MID-7654/7652 with the Strain-Relief Bar Installed
1
Rear Guard Assembly
2
Strain Relief Bar
1
2