INSTALLATION GUIDE
NI HDD-8265 Battery Pack
Accessory
This guide explains how to install the NI HDD-8265 Battery Pack
Accessory. Complete the following steps to install the battery pack
accessory:
1.
Remove the NI HDD-8265 chassis cover by unscrewing the rear
thumbscrew and two side screws (one on each side of the chassis), as
shown in Figures 1 and 2, and sliding the cover toward the rear of the
chassis. A #2 Phillips screwdriver (not included in the kit) is
recommended to remove each side screw.
Figure 1.
Removing the Rear Thumbscrew
Figure 2.
Removing the Side Screw
