Figure 13. Installing an I/O Module in the Chassis
1
2
1. Insertion Groove
2. Latch
3. Squeeze the latches and insert the I/O module into the module slot.
4. Press firmly on the connector side of the I/O module until the latches lock the
I/O module into place.
5. Repeat these steps to install additional I/O modules.
Removing I/O Modules from the Chassis
Complete the following steps to remove a C Series I/O module from the chassis.
1. Make sure that no I/O-side power is connected to the I/O module.
2. Squeeze the latches on both sides of the module and pull the module out of
the chassis.
Connecting the Chassis to Earth Ground
You must connect the chassis grounding screw to earth ground. Refer to the
following figure for the location of the grounding screw. Complete the following
steps to connect to earth ground.
ni.com
14
NI-9146 Safety, Environmental, and Regulatory Information
