Getting Started with the NI 17xx
2
ni.com
❑
5-position lighting connector (additional/replacement plugs
for use with the lighting connector are available from NI,
part number 780260-01)
In addition to the items included in the smart camera kit, the
following components are necessary to set up and configure the
smart camera:
❑
One or two CAT 5 10/100Base-TX or CAT 5e or CAT 6
1000Base-T Ethernet cables. One Ethernet cable is required to
connect the smart camera directly to the development
computer. Two Ethernet cables are required to connect the
smart camera to the development computer through a network.
Note
A CAT 5e or CAT 6 1000Base-T Ethernet cable is
required to achieve maximum 1,000 Mbps (Gigabit)
Ethernet performance. CAT 5e and CAT 6 Ethernet
cables adhere to higher electrical standards required for
Gigabit Ethernet communication. CAT 5 cables are not
guaranteed to meet the necessary electrical requirements.
While CAT 5 cables may appear to work at 1,000 Mbps
in some installations, CAT 5 cables are likely to cause
increased bit errors resulting in degraded or unreliable
network performance.
❑
One of the following power supply options:
Caution
Use the smart camera only with a 24 VDC, UL
listed, limited power source (LPS) supply. The power
supply will bear the UL listed mark, LPS. The power
supply must also meet any safety and compliance
requirements for the country of use.
–
NI desktop power supply (part number 780237-01) and
power supply cord. Refer to
ni.com
for the power supply
cord part number specific to your region and ordering
information.
–
Any 24 VDC, +20%/–15% (IEC 1311) power supply and
one of the following cable options for connecting to the
power supply and I/O:
•
15-pin D-SUB pigtail cable, 5 m (part number
197818-05)
•
15-pin D-SUB to 15-pin D-SUB cable, 2 m
(part number 197817-02) or 5 m (part number
197817-05), and a 15-pin D-SUB terminal block