SCC Quick Start Guide
6
ni.com
Step 3. Cable the SC-2345/2350 Carrier to
the DAQ Device
Caution
Refer to the
Read Me First: Safety and Radio-Frequency Interference
document
before removing equipment covers or connecting/disconnecting any signal wires.
The DAQ device should already be installed in your computer. Refer to the
DAQ Quick Start Guide
for installation instructions.
Connect the SC-2345/2350 carrier to the DAQ device with a 68-pin
shielded cable. If you are using an M Series DAQ device with two
connectors, connect the cable to connector 0 or 1. Use connector J24,
shown in Figure 2, on the SC-2345/2350 carrier.
Figure 2.
Connector J24 Location
The chassis ground terminal on the SC-2345/2350 carrier and the
electromagnetic interference (EMI) gasket attached to the strain relief of
the SC-2345 connector block are for grounding a floating source (1 mA
maximum). Do
not
use these terminals as safety earth grounds. For more
information about the SC-2345/2350 carrier, refer to the
SC-2345/2350
Carrier User Manual.
1
Connector J24
2
Power LEDs
3
SC-2345 Carrier
2
1
Digital I/O
or 1st Stage
of a Dual Stage
AI Configuration
Digital I/O
or 1st Stage
of a Dual Stage
AI Configuration
General Purpose
Counter/Timer
Channel 0
General Purpose
Counter/Timer
Channel 1
Analog Output
DAC 1
Analog Output
DAC 0
Single Stage AI
or 2nd Stage
of a Dual Stage
AI Configuration
Single Stage AI
or 2nd Stage
of a Dual Stage
AI Configuration
3
