Chapter 2
Installation
2-4
ni.com
Clean the device and accessories by brushing off light dust with a soft,
nonmetallic brush. Remove other contaminants with a stiff, nonmetallic
brush. The unit
must
be completely dry and free from contaminants before
returning it to service.
You
must
insulate signal connections for the maximum voltage for which
the device is rated. Do
not
exceed the maximum ratings for the device.
Remove power from signal lines before connection to or disconnection
from the device.
Installation
Install the IMAQ 1426 in any open, compatible expansion slot in the
PCI system. Refer to the
IMAQ PCI-1426 Specifications
for the typical
power requirements for this device.
The following instructions are for general installation. Consult the
computer user manual or technical reference manual for specific
instructions and warnings.
Caution
The IMAQ 1426 is a sensitive electronic device shipped in an antistatic bag.
Open only at an approved workstation and observe precautions for handling
electrostatic-sensitive devices.
Note
You must install the NI-IMAQ driver software before installing the IMAQ 1426
device. Refer to the
Getting Started with IMAQ for Windows 2000/NT/XP
for information
about how to install NI-IMAQ.
1.
Power off and unplug the computer.
Caution
To protect yourself and the computer from electrical hazards, the computer must
remain unplugged until the installation is complete.
2.
Remove the cover to access the PCI expansion slots.
3.
Choose an unused PCI slot, and remove the corresponding expansion
slot cover on the back panel of the computer.
4.
Touch a metal part on the computer case to discharge any static
electricity that might be on your clothes or body before handling
the IMAQ 1426. Static electricity can damage the device.
5.
Gently rock the IMAQ 1426 into the slot. The connection may be tight,
but do not force the device into place.
