![background image](http://html2.mh-extra.com/html/national-instruments/fieldpoint-fp-1001/fieldpoint-fp-1001_quick-start-manual_3420415011.webp)
B. Check/Set the Baud Rate
Every module on one serial port of the host computer must have the same baud rate,
which must be less than or equal to the baud rate of the computer serial port. The
default baud rate for the FP-1000/1001 is 115200, which provides the fastest
performance. You should not need to change this setting unless you experience
communication problems.
C. Apply the New Settings
1. Note the new settings on the FP-1000/1001 label so that you can refer to them when
you configure the software.
2. If power is applied to the network module, cycle it off and back on again to enable
the new settings.
11
FP 1000/1001 Quick Start Guide
©
National Instruments Corporation
300
1200
2400
9600
19200
38400
57600
115200
(Default)
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Network Module
Baud Rate
Switch Positions
6-8
Network Module
Baud Rate
Switch Positions
6-8
Network Module
Baud Rate
Switch Positions
6-8
322731e.qxd 4/4/2003 3:40 PM Page 11