Removing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the cRIO-9032. If the system is in a nonhazardous location, the
cRIO-9032 can be powered on when you remove modules.
Installing the Antennas
Complete the following steps to install the antennas on the cRIO-9032.
Note
NI recommends connecting both antennas for optimal wireless performance
and reliability.
2
1
1.
Screw an antenna to the primary wireless connector. Hand tighten the antenna to the
connector.
2.
Screw an antenna to the secondary wireless connector. Hand tighten the antenna to the
connector.
Connecting the cRIO-9032
The cRIO-9032 has the following connectors, LEDs, and buttons.
NI cRIO-9032 Getting Started Guide
|
© National Instruments
|
7
