Installing Software on the Host Computer
Before using the cRIO-9032, you must install the following application software and device
drivers on the host computer in this order:
1.
LabVIEW 2015 SP1 or later
2.
LabVIEW Real-Time Module 2015 SP1 or later
3.
LabVIEW FPGA Module 2015 SP1 or later
1
4.
NI CompactRIO Device Drivers August 2016 or later
For minimum software support information, visit
swsupport
.
Installing C Series Modules
Complete the following steps to install a C Series module.
3
2
2
1
1.
Verify that power is not connected to the I/O connector(s) on the C Series module. If the
system is in a nonhazardous location, the cRIO-9032 can be powered on when you install
modules.
2.
Press the latches on the C Series module.
3.
Align the C Series module with a slot and seat it in the slot until the latches lock in place.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9032, LabVIEW FPGA Module is required.
6
|
ni.com
|
NI cRIO-9032 Getting Started Guide
