National Instruments 779640-01, User Manual, Page: 3 / 20

© National Instruments Corporation 3 USB-6525 User Guide and Specifications
Refer to the Safety Guidelines section of this document for important safety
information.
Setting Up Hardware
Complete the following steps to set up the hardware:
1. Install combicon screw terminal blocks by inserting them into the
combicon jacks.
Note The USB-6525 kit ships with signal labels. You can apply the signal labels on the
screw terminal blocks for easy signal identification.
2. Refer to Table 1 and Figure 4 for label orientation and affix provided
signal labels to the screw terminal blocks. Insert the screw terminal
blocks into their respective matching combicon jacks. Refer to
Figure 4 for more information about signal label orientation.
Figure 4. Signal Label Application Diagram
3. Connect the wiring to the appropriate screw terminals.
1 Overlay Label with Pin Orientation G u ide s
2 Combicon Jack
3 Screw Terminal Block s
4 Signal Label s
4
3
3
2
1
4