24
Maintenance
403079_RevB
REPLACING THE FILTER
1. Turn off the dust collector by pressing the motor STOP buttons.
2. Disconnect the dust collector plug from the power socket.
IMPORTANT!:
WEAR APPROPRIATE PERSONAL PROTECTION EQUIPMENT.
3. Block the dust collector by means of the wheel locks.
4.
Lift the lever that locks the Longopac® container. Remove the Longopac® container.
5.
Release the retainers that hold the motor head. Lift the motor head and rest this on a flat surface being careful not to damage the power
cable.
IMPORTANT!
ALL THE MATERIAL TRAPPED BY THE FILTER AND THE FILTER ITSELF MUST BE DISPOSED OF THROUGH
AUTHORIZED CHANNELS IN THE COUNTRY WHERE THE DUST COLLECTOR IS USED.
6.
Remove from underneath the dust collector the pin (A) and spring pin (B) that fasten the filter to the shaking lever.
7.
Lift the filter complete with support.
8.
Loosen the clamp and remove the support ring with seal.
9.
Remove the knots and take out the pocket filter. Fit the new filter, put everything back together carefully and fit the cap back on.
CAUTION!
HAND CRUSHING HAZARD
10.
The Longopac® container locking operation should be performed by one person only, who must lower the back side lever with both
hands.
