CHANGE REAR WHEEL (FIG. 1)
1. Jack machine up by pushing the cylinder lift forward to lower and adjust the angle of
the cutting head to raise machine.
2. Place blocks under forklift cups on the side of the machine that wheel is being
changed.
3. Let cylinder down resting machine on blocks allowing rear wheel to be lifted off the
floor.
4. Remove five 1/2’’ lug nuts with an extended arm wrench, remove wheel.
5. Replace wheel.
6. Replace five lug nuts and tighten, making sure lug nuts are very tight.
7. Raise cylinder to raise machine off of blocks. Remove blocks and lower machine.
8. Repeat on other side if necessary.
CHANGE CASTER
Keep clean and free of debris; ensure it can move freely.
1.
Give a shot of grease in grease fitting on caster every month to keep caster moving
freely.
2. To remove caster, machine will need to be raised. Push the cylinder lift lever forward
to lower and adjust the angle of the cutting head to jack up the machine. Block up
machine with wooden block. Remove four bolts, pull caster off and clean/replace
as needed.
3. Replace caster.
4. Pull caster toward rear of machine; re-place and tighten the four bolts.
5. Lower the machine.
CHANGE MOTOR
1. Disconnect motor from power.
2. Lift hood and secure in place.
3. Remove pump.
4. Loosen screws and nuts.
5. Raise motor; disconnect electrical connections.
6. Remove and replace motor.
SEAT REPLACEMENT
1. Rotate hood to bumper stops.
2. Remove four nuts securing seat rails.
3. Replace seat; screw on nuts.
FIG. 1
Maintenance
22
406746_6700_RevC