INSTALLATION AND OWNER’S MANUAL
N945 LIGHT BAR for Kawasaki® VN2000
PARTS LIST
Small, Thin Flat Blade Screwdriver to remove caps
on headlight shell.
Screwdriver, #2 Phillips
8mm Socket, Handle and 3” Extension
Hex Key 5mm
Pliers, Slip Joint and Scissors
Description
Qty.
Light bar Assembly, N945
1
Connectors, Scotchlok
6
M6 x 16 Screw
2
Washer , Flat
2
1.
Make certain the motorcycle is securely positioned for this
installation. Cover the front fender with a protective cloth to avoid scratches.
2
. Remove caps that cover the headlight screws. Remove headlight screws.
(Small Screwdriver and #2 Phillips Screwdriver) Figure 1 and 2.
3.
Disconnect headlight at two places. Set light aside.
Figure 3.
4.
Disconnect the
Right (Orange)
and
Left (Blue)
turn signal connectors.
5.
Remove the Screws with the 8mm hex head that hold the turn signal bar
to the under side of triple clamp. Remove turn signal bar. Bar and screws
will not be re-used.
(8mm Socket) Figure 4.
PREPARATION
INSTALLATION
6.
Mount the Light Bar Assembly. Hold Light Bar in place at underside of
triple clamp. Use the M6 x 16 Screws with a Flat Washer to install the Light
Bar assembly. Tighten Firmly.
(5mm Hex Key) Figure 5.
7.
Route the Light Bar Wires to the back and into headlight shell.
WIRE LIGHT BAR
HELPFUL WIRE TIPS: A.
Keep the Right and Left Wires of the Light Bar in
separate groups.
B.
Inside the headlight shell, the wires bundled in the Blue
Connectors are for Right side operation and Orange Connector is Left.
C.
You will need to remove 2-3” of electrical tape from the Blue/Yellow Stripe,
Low Beam Wire inside the headlight to have room for two Scotchlok
Connectors going to this wire.
(Scissors) Figure 6.
8.
Attach wires as recommended in the following list.
Do one at a time and check for correct operation.
(Connectors and Pliers).
LIGHT BAR MAIN SPOT
MOTORCYCLE
Left and Right SHORT BLACK to Blue /Yellow Stripe,
Low Beam
LIGHT BAR TURN SIGNAL
Right LONG RED
to Grey Wire
(in Blue Bundle)
Left LONG RED
to Green Wire
(in Orange Bundle)
LIGHT BAR RUNNING LIGHTS
Right LONG BLACK
to Red wi/Blue Stripe
(in Blue Bundle)
Left LONG BLACK
to Red wi/ Blue Stipe
(in Orange Bundle)
9.
Test lights. Re-install headlight and rim.
NOTE:
right and left on the motorcycle are deter-
mined from the rider’s position.
Wire From
Light Bar
Insert To
Stop.
Through Wire
NOTE:
An assistant to hold light bar will be helpful in step 6.
Figure 2
Figure 4
Figure 1
Figure 3
Figure 5
