1. HORIZONTAL AIM
A.
To adjust the Spotlights or Turn signals right or left gently
rotate the lamp into the correct position. In the event that the
lamps become loose, refer to the procedure for vertical adjust-
ment.
2. VERTICAL AIM
A
. Loosen the nut on the Spotlight stud, adjust the Spotlights
by rotating into position, tighten firmly.
(11/16” Wrench)
ADJUSTMENT
MAINTENANCE
The high quality chrome finish of your National Cycle light bar
can be maintained with any quality chrome cleaner and /or polish.
REPLACEMENT PARTS and ACCESSORIES
Order parts through your local dealer or contact National Cycle.
Description
Part No.
Light Head Assembly
90-910570-000
Lamp Assembly E13/DOT
Reflector, Lens and Bulb
90-901012-000
Turn Signal
Assembly
90-930921-000
Turn Signal Lens
90-930213-000
Turn Signal Bulb Only: Bulb 1157 Available at Most Auto Parts Stores.
Light Bar Accessories
Chrome Visor
N9005
Alternate Thumb Switch
N9001
After wiring the light bar check for clearance. Make sure the
wires can not get pinched when the fork is turned to a full fork
lock left and right.
Check all lights for proper operation.
Check the tightness of all fasteners that have been involved in
this installation.
Installing optional N9005 Light
Head Visor.
1.
Loosen the rim of the light
head assembly. (Phillips Screw
Driver).
2.
Slip taps of Visor under rim.
Item E.
3.
Shape Visor / Visor Tabs to
conform to contours of light head
assembly.
4.
Retighten rim.
E
To adjust vertical aim you will need these
additional tools:
11/16” Open Ended Wrench
Figure 6
NOTE:
check vertical aim of the lamps. They should
aim approximately 5° downward. If adjustment is
required see “Adjustment” page 2 of this instruction
otherwise proceed with wiring step 2.
Shop for other auxiliary lights on our website.
