Natcomm
Page 9
INSTALLATION FOR CORDLESS PHONE USERS
If you operate a Single Cordless Phone Base Station only, with 1 or more handsets,
then installation is very easy:
1.
Unplug the Base Station Telephone Cable from the Telephone Socket.
2.
Connect this cable to the LINE OUT Port of DS1.
3.
Connecting the LINE IN port of DS1 to the telephone using a supplied cable.
Installation by a technician is not required.
4.
Arrange for a Suitable Qualified Technician to install your Door Phone in the
required location, following the Instructions supplied with the Door Phone.
MULTI SOCKET USE INSTALLATION
Installation is required by a Suitably Qualified Technician
Where you will operate cordless or corded telephones connected to more than 1
telephone socket, an approved installation technician will need to fit your DS1 direct
onto your incoming telephone line, immediately ahead of your first telephone
socket, so that your telephone line connects to all of your telephone sockets
through it.
DS1 has been designed so that it will not interfere with the normal use of your
telephone line in any way. In the event of a malfunction or power cut, your
telephone line will continue to operate.
Your DS1 unit should be fitted inside the home or office. If it is fitted outside next to
the Door Phone, then it MUST be fitted within a Water Proof enclosure.
These instructions are for suitably qualified Installation Technicians.
1)
Locate the FIRST telephone socket on the line. Fit a New
Telephone socket next to it, or alternatively replace the Existing
Telephone socket with a Double Outlet RJ type telephone socket.
Label the Original Telephone Socket - LINE IN
Label this New Telephone Socket - LINE OUT
