Natcomm
Page 17
PROGRAMMING PROCEDURE
1.
TURN OFF POWER TO YOUR UNIT
2.
SWITCH ON POWER AND PRESS # (WITHIN 30 SECONDS)
3.
You must use a telephone connected to
DS1
.
4.
YOUR UNIT WILL OUTPUT 3 SHORT ‘BEEPS’
5.
Do not proceed until you have heard 3 short beeps. If you do not
hear 3 beeps, return to the start (1).
6.
To enter the NUMBER OF RINGS press #1xx
where xx = number of rings and can be 01-99
(for example, press #105 for 5 rings)
(for example, press #115 for 15 rings)
7.
TO EXIT PROGRAMMING MODE - HANG UP.
IMPORTANT NOTE
After each power up
DS1
will prepare to enter programming mode for 30
seconds. During this time, dial tone is not available.
You can cancel out of this mode (before the 30 second limit) and achieve
dial tone by Hook Flashing, Hanging Up OR pressing any DTMF Touch
Tone digit other than #.
