4.5 Maintenance
This page allow you to update NAS dongle firmware, go back to default setting or reboot
NAS system.
Firmware update: Follow the steps below to update the loader and firmware for NAS
Dongle.
1.
Download the latest firmware form your vendor’s website
2.
Store the firmware file on your computer and decompress them if necessary
3.
Browse your system and locate the firmware (BIN file)
4.
Click on “upload”
5.
Confirm the pop-up massage to start the update.
6.
Wait and DO NOT click anywhere else or turn off the power! This might take a few
minutes.
7.
Once the update is done, it will prompt you to reboot the device.
8.
Click on ”reboot” to restart the device.
9.
Wait for about one minute and then go to the status page to confirm the update was
successful.
Factory defaults: if you experience problems and after a firmware update, it is
recommended to reset all setting.
Note: Resetting the device will remove all folder form the sharing list, erase the FTP
accounts, and reset all other settings! Please do not power off or disconnect NAS Dongle
connection during the firmware update process.
