NARGESA H2, Instruction Book

Page: 23 / 34

INSTRUCTIONS BOOK FOR FURNACE H2 22
6. POSSIBLE BREAKDOWNS
BREAKDOWN CAUSE SOLUTION
The furnace might
not ignite Unproper gas connections To connect correctly the gas plug and make
sure that the
Adaptor of the gas bottle is
properly fit. See section 5.4
The Manometer of the Pressure
Regulator shows 0
Open the Pressure regulator and the flow of
the Adaptor in the gas bottle
Gas valve 1 is closed Open Gas Valve 1 just some degrees.
Gas Valve 1 is way too open Close a Gas Valve 1 a few degrees
Electronic
switching does not
generate the
ignition spark Place the spark pkug 4mm away from the
Burner 1
The spark plug is more tan 4mm
away from
Burner 1
Place the spark plug 4mm from Burner 1
Inner battery has been exhausted
e ha agotado la pila interior Change the inner battery (AA, 1,5v)
The flame turns to
be turbulent. Reduce the amount of fuel by closing gradually
the
Gas Valve 1.
Excesss of fuel in the blend of air
and gas.
Reduce the job pressure
The gas injector is stuck or dirty Replace the injector
The flame turns
orange Lack of fuel in the bland of air and
fuel. Increase the amount of fuel by opening the
Gas Valve 1 gradually.
The gas injector is stuck or dirty Replace the injector
The air inlet is dirty Clean up the furnace air inlet.
The flame goes
out of the
combustion
chamber Excessive gas pressure Reduce the gas pressure
If the problem goes on, please contact our technical assistance in Nargesa
+34 972568085 +34 620446827 sat2@nargesa.com sat2.nargesa