NARGESA CC60, Instruction Book

Page: 33 / 63

- 32 -
NON - MANDREL TUBE AND PIPE BENDER CC60
5.14. Calibrating the Touchscreen
The touchscreen is factory - calibrated for use. However, it may need to be calibrated if it does not accu-
rately respond to the actions of the operator using it.
To proceed adequately, first press the key to access the menu window. Once here, press the key
Upon doing so, the message shown below will appear on the screen:
If you accept by pressing , the touchscreen calibration process begins. The information on the screen
will change to this:
There is a cross in the middle of the window which must be pressed for a few seconds until it moves to a
new position. This process is repeated at different points on the screen until the touchscreen calibration
has finished.