NARGESA CC60, Instruction Book

Page: 21 / 63

- 20 -
NON - MANDREL TUBE AND PIPE BENDER CC60
5.6. Angle Correction
If the curving angle needs to be corrected, you must stop the curving process and indicate the necessary
correction. Press the icon and enter the number of degrees required for correction; in this case, 2
degrees.
Confirm by pressing the key and proceed with another curve. You must press again to
start the cycle.
5.7. Radius Arm
If a large - size pipe is selected, the machine indicates you must install the radius arm. Example:
A pipe with a diameter of 50 mm, a roller radius of 150 and pipe thickness of 2 mm .
If this part must be installed, the icon indicated will appear on the screen:
Install the Radius arm by following the instructions in Section 5.2. Assembling the Radius Arm.
IMPORTANT: Whenever the machine indicates the Radius arm is necessary, it must be installed.
Not installing it could cause irreparable damages to the machine.