NARGESA CC60, Instruction Book

Page: 29 / 63

- 28 -
NON - MANDREL TUBE AND PIPE BENDER CC60
IMPORTANT: The general data are the same for the entire program; in other words, if they are changed
for a specific curve, they will be changed for the entire program.
Enter the angle at which you wish to make the curve in the second operation; in this case, 45 degrees.
Now, the program has two curves programmed, the first at 90 degrees and the second at 45 degrees.
Add all curves needed by pressing the
+ key and enter a new radius of curving.
For cases where you must make two curves at the same degrees, a new operation does not need to be
added to the program. Use the repetition tool by pressing the
icon and add the number of times this
curve should be repeated. In this case, the machine will make 3 curves at 45 degrees as part of the num-
ber 2 curving in the program.