NARGESA C3006, Instruction Book

Page: 29 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 28
Then insert the second number (4), followed by the third one (3), these are shown on screen:
Picture 52. Inserting a new figure
Picture 53. Inserting a new figure
After press the key according to the Decimal point and it will be seen on screen what comes below:
Picture 54. Inserting a new figure
Finally insert the last number (2, in this case), you will get a new figure, as it can be seen in Picture 55:
Picture 55. Inserting a new figure
Once these simple steps are made, press the Return key to continue in order to confirm the inserted
value.You could see on the display the information shown in the picture below, whenever the new inserted
figure is not higher than the top length:
Picture 56. Detail of block 2 with the new figure in cell nº 9
Any time you want to cancel the operation while you are inserting a new figure, just press the ESC key.
Then you will see the block again on the screen , as well as the cell you were before deciding to insert a
new figure.
BLOCK 02 0000 AU
........................ 54 mm
BLOCK 02 0000 AU
........................ 443 mm
BLOCK 02 0000 AU
........................ 443 mm
BLOCK 02 0000 AU
........................ 443 mm
BLOCK 02 0000 AU
CELL 9 = 443.2 mm