NARGESA C3006, Instruction Book

Page: 19 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 18
5.6.3. Considerations to bear in mind
It is impossible to insert a figure higher than the total effective length of the top. It is like that because it is
not possible to put the top beyond the physical limits that it has itself.
Therefore, if the total effective length of the top is 500.0 mm, we will see the memory of the current topwith
the value it had before, although we can insert on the screen a value higher to this one,such as 550.0 mm,
when we press the Return Key to confirm the new figure, we see the memory of the current top again with
the value that it had before its modification.
Picture 25. Information of the memory of the top 0
Picture 26. Modificating the memory of the top 0
When pressing the key return to confirm and due to the fact that the inserted figure is higher to the total
(500.0 mm), the top will not move and in the screen we will see the label on Picture 25 again:
Picture 27. Information of the top memory 0
5.7. Operation mode
As it has been pointed out before, the shears has two modes of performance, in order to make the cutting
operations. These are: Manual mode and Automatic mode.
In the memories of the top, the performance mode of the machine is Manual on default. This performance
mode is the same for each o f the 10 memories the top has and that could be changed if desired. Just
follow the steps detailed below if the performance mde of the shears wants to be changed:
If your intention is to work with the machine in the automatic mode, press the AUTO key. Once this has
been done you will see how the shears blade will go up til the upper rest position.
If on the other hand your intention is to operate in Manual mode, the only thing to do is to press the Manual
key. In this case, unlike the previous one, the blade will not move.
M00 CONT: 0000
TOP = 50.0 mm
M00 CONT: 0000
TOP = 550.0 mm
M00 CONT: 0000
TOP = 50.0 mm