PACIFIC D23
20 |
P a g e
PACIFIC D23
Nardi Compressori – www.nardicompressori.com
7.06
CHANGE OIL FILTER (Only for compressors with oil pump):
The steps for changing the oil filter are as follows (this is to be performed at
every oil change) :
•
Unscrew the nut of the fitting that holds the tube that
delivers the oil to the last cylinder using a 14mm
wrench and disconnect it.
•
Unscrew the four screws of the oil filter housing
using a Phillips screwdriver.
•
Lift the oil filter housing cap with the tube attached to
it and
remove the filter.
•
Check if it is necessary to change the O-ring on the oil filter house
housing.
•
Close everything, turn on the compressor and make sure there are no oil
leaks.
7.08
CHANGE INTAKE FILTER:
The filter traps any impurities present in the environment. It must be replaced at regular intervals as indicated in the
maintenance checklist.
It should not be washed but replaced.
The steps for changing the filter are as follows:
•
Release the latches on the lid and remove the filter cartridge.
•
Clean with a damp cloth inside the filter housing and the cap.
Insert the new filter cartridge and close the lid.
