7
System installation
Must not directly connect this product with battery beyond fuses.
2.Mainframe installation
★
Firstly, take out the original car’s mainframe.
★
Dismantle the car loading bracket and screws, conserve them.
★
Use those screws to fix the original car’s bracket on the mainframe of
navigator.
★
Must not directly connect product’s power cable with other circuit’s power
cable.
★
Then connect all mainframe’s lines according to the installation schematic
diagram.
★
Finally, install mainframe in the right place and fasten it with original car ’s
bracket screw.
Notice: do not damage and pollute instrument desk during installation.
3. GPS antenna installation
Choose car inside to install antenna (on the back board), paste the metal
plate in a possible level surface to make GPS antenna toward the skylight.
Place the GPS antenna on metal plate. (GPS antenna is fixed by its magnetic
body)
Note: When pasting metal plate, don’t cut it into small pieces. Since
some types of vehicles don’t allow GPS satellite signals penetrate
through, at this time, should be installed GPS antennas outside the car.