42
W415-1004 / B / 08.10.12
10.0 OPERATION
Ensure that a continuous gas flow is at the burner before installing the door. When lit for the first time, the appliance will emit an odor for a
few hours. This is a normal temporary condition caused by the "burn-in" of paints and lubricants used in the manufacturing process and will
not occur again. After extended periods of non-operation such as following a vacation or a warm weather season, the appliance may emit a
slight odor for a few hours. This is caused by dust particles in the heat exchanger burning off. In both cases, open a window to sufficiently
ventilate the room.
FOR YOUR SAFETY READ BEFORE LIGHTING:
A.
This appliance is equipped with an ignition device which automatically lights he pilot. Do not try to light by hand.
B.
Before operating smell all around the appliance area for gas and next to the floor because some gas is heavier than air and will settle on
the floor.
C.
Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try to repair it. Call a qualified
service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and
replace any part of the control system and any gas control which has been under water.
Ɣ
Turn off all gas to the appliance.
Ɣ
Open windows.
Ɣ
Do not try to light any appliance.
Ɣ
Do not touch any electric switch; do not use any phone
in your building.
1.
Stop! Read the above safety information on this label.
2.
Turn remote wall switch to off position.
3.
Turn off all electrical power to the appliance and remove batteries.
4.
This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
5.
Turn manual shutoff valve clockwise to off.
6.
Open the glass door.
7.
Wait five (5) minutes to clear out any gas. If you smell gas including near the floor, STOP! Follow “B” in the
above safety information on this label. If you don’t smell gas go to the next step.
8.
Close the glass door.
9.
Turn manual shutoff valve counter-clockwise to on.
10.
Turn on all electrical power to the appliance and re-install batteries.
11.
Turn on remote wall switch to on position.
12.
If appliance will not operate, follow instructions “TO TURN OFF GAS” and call your
service technician or gas supplier.
1.
Turn off remote wall switch to the appliance.
2.
Turn off all electrical power to the appliance if service is to be performed.
3.
Turn manual shutoff valve clockwise to off. Do not force.
Ɣ
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
Ɣ
If you cannot reach your gas supplier, call the fire
department.
WHAT TO DO IF YOU SMELL GAS:
LIGHTING INSTRUCTIONS:
TO TURN OFF GAS
Manual Shut-off
Valve Shown in
“OFF” position
.
47.6
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
THE GLASS DOOR OPENED OR REMOVED.
!
WARNING
