18
W415-0583 / D / 07.24.07
3.
Remove optional front, glass door, bowl w/ rocks, burner,
decorative panel, & burner bottom.
4.
The blower mounting plate can now be removed. Remove
the four screws that secure the plate to the fi rebox base.
5.
The blower is secured to the fi rebox. Disconnect the wire
connectors before attempting to remove the blower from the
fi rebox.
6.
Remove the two screws securing the blower and lift through
blower access opening.
Note:
When re-installing the replacement blower, it will be
necessary to replace the gasket (W290-0104) on the blower
mounting plate.
FIGURE 41
BLOWER
MOUNTING
PLATE
REMOVE 4 SCREWS
REMOVE 2 SCREWS
FIGURE 42
BATTERY REPLACEMENT
1.
Remove the optional front. (In-
structions on Pg. 17)
2.
Tilt the control panel forward al-
lowing access to the electode box
which is screwed to the base of the
fi rebox. (Fig. 43)
BOWL
BURNER
CURVED
DECORATIVE
PANEL
BURNER
BOTTOM
BURNER
BASE
SEE-TH
RU
W
IN
D
O
W
ELECTRODE
BOX
(AA Battery
Required)
CONTROL
PANEL
CONTROL PANEL
FIGURE 43
Yo u r
comes equipped with a heat circulating blower.
The blower is pre-wired and is controlled by the remote con-
trol supplied with the unit. For control details, see operation.
Pg. 20.
Drywall dust will penetrate into the blower bearings, caus-
ing irreparable damage. Care must be taken to prevent
drywall dust from coming into contact with the blower or
its compartment. Any damage resulting from this condi-
tion is not covered by the warranty policy.
1.
Turn off the power to the fi replace.
2.
Turn off the gas valve.
BLOWER REPLACEMENT
