19
EN
www.napoleon.com
N415-0526CE-GB-DE DEC 10.19
Problem
Possible Causes
Solution
Ignitor, oven and cabinet
lights work but the knob
lights don’t illuminate
when turning the power
switch ON
The motion sensor detector does not work
properly
The wire harness does not work properly
Ensure the blue indicator is ON
Turn the sensor ON by clicking the motion
detector button
If blue indicator is ON, replace the motion
sensor
Replace the wire harness of the control panel
Illumination of the knob
and switch lights work
fine, but the side/rear
burner ignition does not
work
The ignitor switch does not work properly
The ignitor block does not work properly
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside the
control panel If there’s no light on the switch
when you turn it on.
Replace the ignitor block if the switch
illuminates and sparking noise can be heard.
Illumination but can’t
ignite the side or rear
burner, even when
sparking noise occurs
The gap between electrodes is too big or
too small
Adjust the gap between two prongs of the
side burner electrode when the side burner
does not ignite.
Adjust the gap between the electrode and the
rear burner when the rear burner when the
rear burner foes not ignite
The knob and switch lights
blink eight times with
0.5 seconds intervals and
then turn off.
The batteries are low
Replace the batteries
