9
BURNER
- The burner is made from heavy wall 304 stainless steel, but due to the extreme heat and corrosive environment,
surface corrosion will occur. Use a brass wire brush to remove surface corrosion. Clean any blocked ports using an opened
paper clip. Do not enlarge the burner ports. Spiders and insects are attracted to the smell
of propane and natural gas. The burner is equipped with an insect screen on the air
shutter, which will reduce the likelihood of insects building nests inside the burner, but
does not entirely eliminate the problem. The nest or web will cause the burner to burn
with a soft yellow or orange flame or cause a fire (flashback) at the air shutter underneath
the control panel. To clean the inside of the burner, it must be
removed from the gas grill. Remove the screw(s) located either in the
center of the burner on 308 models, or above the burner to the left and
right of the centre of the burner on 450 models. Lift back of burner
upwards to remove. Use a flexible venturi tube cleaning brush to
clean out the inside of the burner. Shake any loose debris out of the
burner, through the gas inlet. Ensure that the insect screen is clean,
tight, and free of any lint or other debris. Check also that the valve
orifices are clean. Do not enlarge the orifices. Re-install the burner.
Check that the valve enters the burner when installing. Replace
burner cover and mounting screws to complete installation.
ALUMINUM CASTINGS
- Clean castings periodically with warm
soapy water. Aluminum will not rust, but due to high temperatures
and weathering, oxidation can occur on aluminum surfaces. This will appear as white spots on the castings. To refinish the
castings, clean them and sand lightly with fine sandpaper. Wipe surface to remove any residue, and paint with high
temperature barbecue paint. Protect surrounding areas from over-spray. Follow curing directions found on the can.
TROUBLESHOOTING
Screw
Problem
Possible Causes
Solution
Low heat / Low flame when
valve turned to high.
For propane - improper lighting
procedure.
Ensure lighting procedure is followed carefully. All gas grill
valves must be in the off position when the tank valve is
turned on. Turn tank on slowly to allow pressure to
equalize. See lighting instructions.
For natural gas - undersized
supply line.
Pipe must be sized according to installation code.
For both gases - improper
preheating.
Pre-heat grill with both main burners on high for 10 to 15
minutes.
Excessive flare-ups/uneven
heat.
Sear plates installed incorrectly.
Ensure sear plates are installed with the holes towards
the front, and the slots on the bottom. See assembly
instructions.
Improper pre-heating.
Pre-heat grill with both main burners on high for 10 to 15
minutes.
Excessive grease and ash build
up on sear plates and in drip
pan.
Clean sear plates and drip pan regularly. Do not line pan
with aluminum foil. Refer to cleaning instructions.
Burners burn with yellow
flame, accompanied by the
smell of gas.
Possible spider web or other
debris, or improper air shutter
adjustment.
Thoroughly clean burner by removing. See general
maintenance instructions. Open air shutter slightly
according to combustion air adjustment instructions.
Improper air shutter adjustment.
Close air shutter slightly according to combustion air
adjustment instructions.
Flames lift away from
burner, accompanied by the
smell of gas, and possibly
difficulties in lighting.
