W415-1329 / 06.25.14
37
EN
6.0 FINISHING
A.
Lift the top casting off and remove the safety screen.
B.
Lift the cast front out of its retainers (located at either side on the top).
C.
Open the valve control cover. Pull the latch handles forward to release. The door may now be safely
removed by swinging the bottom out and lifting it off. To install the door, repeat in reverse order.
The
return
fl
ange must
fi
t over the top of the ridge so that it rests on top of the
fi
rebox.
The 'T' latch portion is threaded and can be loosened or tightened to adjust for an effective door seal.
Care must be taken when re-installing the door to ensure that the gasket at the top of the door does
not bunch.
When installing the glass door, a simple procedure must be followed in order to not damage the door.
LATCH
RIDGE
RETURN
FLANGE
6.1 FRONT CAST REMOVAL
A.
Lift the top casting off the unit.
B.
Loosen the securing bolts on the cast front (located at either side on the top). Lift up and out.
C.
To install the front, repeat in reverse order.
6.2 GLASS DOOR INSTALLATION AND REMOVAL
6.3 SAFETY BARRIER INSTALLATION AND REMOVAL
A barrier designed to reduce the risk of burns from the hot viewing glass, is provided with the
appliance and shall be installed.
A.
Remove the safety barrier by lifting up slightly, swing out bottom then lower screen. Remove and
discard plastic wrap.
B.
Tilt the top of the safety barrier toward the appliance and hook under the top arch of the front casting.
C.
Swing the bottom of the safety barrier into position and lower, allowing the bottom clips to rest on the
bottom opening. Careful not to scratch the bottom casting.
SAFETY
BARRIER
SAFETY
BARRIER