EN
W415-2360 / A / 10.31.19
45
maintenance
9.2 night
light
tm
replacement
9.2.1 bulb
replacement
The GDS26-1 comes equipped with our “Night Light™”. If in the event the lamp or lens needs to be replaced, follow
these instructions.
A.
Turn off all electrical supply.
B.
Remove the safety barrier front and door from the fi rebox.
C.
Unscrew the lens cover making sure the washer stays in place.
D.
The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only (W387-0006), as lamp and
lens are special "high temperature" products.
E.
Replace lens with gasket, lens covers, attach wires to quick connects and replace the door when fi nished.
When re-assembling the light assembly, care must be taken. “Light Leakage” from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
A.
Remove the safety barrier and door from the fi rebox.
B.
Run the wires up through the lens hole.
C.
Align key hole with lens assembly.
D.
Snap into place.
E.
Replace light shields, attach the wires and replace the door to the fi rebox.
A.
Remove the safety barrier and front door and top shield from the
fi rebox.
B.
Compress the retainer fi ns in with a screw driver while pressing fi rmly on
the top of the light assembly.
C.
Once all the retainer fi ns are pushed in the lens assembly will snap out of
place.
KEY HOLE
9.2.2 lens assembly installation
9.2.3 lens assembly replacement
Do not handle the lamp (bulb) with bare fi ngers. Protect
with a clean, dry cloth.
note:
The fi rebox must be sealed.
note:
