34
W415-0663 / C / 03.17.11
Place log #1 onto the burner, centering it on the log
support and pushing it as close to the rear wall of the
fi
rebox as possible.
A
B
Place the charcoal piece (log #5) onto the pins on the
left side of the burner.
F
C
D
E
Place log #6 onto the pins on the right side of the burner.
Sit the bottom of log #2 onto the locating pin on the
left side of the log support. Position the top of the log
into the pocket provided on the top of the rear log (#1).
Position the notch located in the bottom end of log #3
against the centre grate post. Rest the top of log #3 into
the pocket at the top end of log #2.
Place the bottom of log #4 onto the locating pin on the
right side of the log support. Rest the top into the pocket
provided on the center log (#3).
6.4 GD34-1
6.4.1 GLOWING EMBERS
FRONT BURNER PORTS
# 6
# 5
Tear the glowing embers into pieces and place onto the
front row of burner ports, in front of logs #5 and #6. Care
should be taken to shred the embers into
thin, small irregu-
lar pieces
as only the exposed edges of the
fi
bre hairs will
glow when exposed to direct
fl
ame; however care should
be taken to not block the burner ports. Blocked ports can
cause an incorrect
fl
ame pattern, carbon deposits and
delayed ignition.
