Napoleon BIP500RB, Instruction Manual

Page: 19 / 60

www.napoleongrills.com
19
EN
BIP500 BUILT-IN INSTRUCTIONS
3/8”(10mm)
2 x N570-0086 (#14 X1/2”)
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a
qualified installer to local codes.
1. Attach the side mounting brackets to each side of the grill using (4) 1/4 - 20 x 7/8" screws (N570-0087).
2. Attach the rotisserie mount bracket to the side of the grill using (2) #14 x 1/2” screws (N570-0086).
3. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each
wing of the rear trim.
4. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex
supply line to the fitting at the end of the manifold.
5. The entire installation must be leak tested before operating the unit.
4 x N570-0087 (1/4 -20 X 7/8”)
(Pre-installed at factory.)
Heat shield
Drip pan