Napoleon BILEX 605, Manual

Page: 5 / 56

www.napoleongrills.com
5
EN
Technical Data
The following table lists input values for the appliance.
Burner
Orifice Size (Gross) Heat Input (Total) Gas Usage (Total)
I
MAIN 58 (1.07mm) 19.2 kW 1396 g/h
BACK 58 (1.07mm) 5.3 kW 385 g/h
Certified Gases / Pressures - Check rating plate to ensure that it corresponds with following list.
Do not tamper with or modify regulator. Use only regulators, which supply the pressure, listed in the table
above. A regulator of 28-30mbar must be used for butane or a 37mbar regulator for propane. For grills
set up to operate at 50mbar, the grill is equipped with an internal regulator. This internal regulator has an
outlet pressure of 30mbar and must not be modified or adjusted. For replacement, use only the regulator
specified by the manufacturer: Maxitrol model number RV47LSMF.
This unit includes an internal regulator which stabilizes the gas pressure and improves grill performance.
This regulator cannot be adjusted. There is a pressure tap located on the side of the regulator. It can
be used by a qualified service person when servicing the grill to determine if the regulator is functioning
properly. The screw within the pressure tap must always be kept tight, except when performing a pressure
test on the regulator (qualified service personnel only).
Gas Category I
3B/P(30)
I
3+(28-30/37)
I
3B/P(50)
Orifice Sizes (see above) I I I
Gases / Pressures Butane 30mbar
Propane 30mbar
Butane 28-30mbar
Propane 37mbar
Butane 50mbar
Propane 50mbar
Countries DK, FI, NL, NO,
SE
BE, ES, FR, GB, IE,
IT, PT
DE, AT
Gas Hook-Up Instructions
WARNING!
This grill is designed for non-combustible enclosures only, and must be installed and
serviced by a qualified installer to local codes.
WARNING!
Cabinet frame, cabinet, and counter top must be made from non-combustible material.
WARNING!
The pressure supplied to the grill must conform to what is listed on the rating plate of
the grill. If the supply pressure is greater, a regulator must be installed.
BUILT IN PROPANE GAS HOOK-UP : The piping up to the gas grill is the responsibility of the installer and
piping should be located as shown in the built-in instructions. A flexible metal connector is included to
simplify the installation of the unit. Connect this flexible metal connector to the flare fitting on the end of
the manifold. Connect the other end of the connector to the gas piping. Ensure that the connector does
not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use a hose to
connect the unit except to connect the cylinder regulator to the piping system. It must be connected with
rigid pipe, copper tube or an approved flexible metal connector which complies with national and regional
codes.