W415-1285 / J / 11.15.19
EN
46
fi nishing
5. Place log #4 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 4 and in the left side view. Place one pin into the left
side hearth pad
(FIG.4)
.
6. Place log #5 onto the pin located in the left side hearth pad and let it
rest on the burner
(FIG.5)
.
7. Place log #6 onto the pin located on the right side corner of the burner,
then place one pin into middle of the log #6 and log #5
(FIG.6).
8. Place log #7 onto the pin located in log #6 and onto the pin in log #5
(FIG.7)
.
9. Place log #8 on the hearth pad and let it rest against the notch in the
side of log #7
(FIG.8)
HINT: The best view of log #8 is shown in the left side view below.
10. Place log #9 onto the pin located in log #6 and let it rest on the right
side corner hearth pad and then place one pin into log #7
(FIG.9)
.
11. Place log #10 onto the pin located in log #7 and let it rest in the middle
of the right side hearth pad, as shown in Figure 10. Place one pin into
log #1
(FIG.10)
.
12. Place log #11 onto the pin located in log #1 and let it rest on the right
end hearth pad
(FIG.11)
.
13. Place charcoal lump #12 onto the two pins located in the center of the
burner
(FIG.12).
14. Install the glowing embers, see "glowing embers" section.
15. Sprinkle the charcoal embers around the log support, see "charcoal
embers" section. (Use illustration below as reference).
16. Place the charcoal lumps on top of the charcoal embers, see "charcoal
lumps" section. (Use illustration below as reference).
Fig. 5
Fig. 4
PIN
1
11
2
3
10
6
9
7
4
12
Fig. 7
10
6
8
5
2
3
4
1
7
11
Fig. 8
PIN
Fig. 9
PIN
RIGHT SIDE VIEW
LEFT SIDE VIEW
Fig. 6
PINS
PIN
Fig. 10
Fig. 11
Fig. 12
Ensure log #5 does not cover any burner ports.
note:
Ensure log #6 does not cover any burner ports.
note:
Do not cover the pilot or burner ports with media or embers. Do not overfi ll.
note:
