19
W415-0496 / B / 08.10.05
LOG PLACEMENT
LOGO PLACEMENT
Remove the backing from the the logo and position onto
the control door as shown.
It is not necessary to remove the cast front, however,
this will make for a more simple log installation.
In order to assemble the log set, the door must be removed,
see
Cast Front
/
Glass Door Removal
in the
FINISHING
section of this manual.
1.
Place the rear log, as shown, onto the rear log support
brackets. Ensure the cutout on the left underside of the log,
fits over the pilot assembly. Bend the bracket on the right
side to help retain the rear log.
2.
Place the hole in the underside of log #2 onto the locating
screw, on the left side of the burner. The fibre burner is
formed to cradle the centre of the log.
3.
Place the hole in the underside of log #3 onto the locating
screw, on the right side of the burner. The bottom branch of
log #3 sits infront of, and against, the right end of log #2.
4.
Reinstall the glass door & front.
BRACKET
LOG LOCATING SCREWS
FIGURE 33a-d
