Napoleon Allure NEFL100FH, Service Manual, Page: 24 / 30

W415-1698 / 12.20.16
24
EN
6.0 REPLACING COMPONENTS
!
WARNING
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE, OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
6.1 MOTOR AND REFLECTOR SPINDLE REPLACEMENT
6.2 CONTROL BOARD REPLACEMENT
TO ACCESS THE FOLLOWING COMPONENTS, REFER TO THE SERVICE PREPARATION SECTION.
1. Remove 2 screws that hold the motor and disconnect the wire connector.
2. Unplug the quick connect motor wire from the wire harness.
3. Pull the motor out of the unit.
For ease of removal, turn the motor
slightly to remove it.
4. To remove the refl ector spindle, pull the refl ector away from the motor for it
to release.
5. Remove the rubber adapter from the motor.
6. Remove two screws holding the motor and take the motor out of the appli-
ance.
7. Install new motor with the refl ector spindle and the rubber adapter.
8. Screw the new motor back into the motor bracket.
1. Unplug all the wires connected to the control board. For ease of wire disconnection, use a pair of
needle-nose pliers.
2. Remove control board from appliance. NOTE: To prevent stripping of the plastic plugs on the back
of the control board, hold the plugs with a pair of needle-noise pliers while removing each of the
screws.
3. Install the new control board into the appliance.
4. Connect all of the wires to the board.
MOTOR
REFLECTOR SPINDLE