Napoleon 9700 SERIES, Installation And Operating Instructions Manual

Page: 4 / 77

W415-1243 / A / 03.19.15
3
IOM
1.0 INTRODUCTION
NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
16.0 OPTIONAL ACCESSORIES (FIELD SUPPLIED/INSTALLED) 44
16.1 ELECTRONIC AIR CLEANER 44
16.2 POWER HUMIDIFIER 44
16.3 EMERGENCY HEAT MODE 44
17.0 INITIAL START-UP PROCEDURES 45
17.1 TO START THE FURNACE 45
17.2 TO SHUT DOWN THE FURNACE 45
17.3 SEQUENCE OF OPERATION 46
17.4 PROGRAMMABLE THERMOSTAT (OPTION) 46
18.0 AIR FLOW 47
18.1 TEMPERATURE RISE CHECK 47
18.2 CALCULATING AIR FLOW 48
18.3 ADJUSTING BLOWER SPEEDS ON ECM 2.3 / EON BLOWER MOTORS 48
18.4 DEHUMIDIFICATION - ECM 2.3 / EON 49
18.5 SETTING BLOWER “ON” AND “OFF” TIMINGS - ECM 2.3 / EON MODELS ONLY 49
18.6 CONTINUOUS FAN OPERATION 49
19.0 MAINTENANCE AND TROUBLESHOOTING 50
19.1 AIR FILTER 50
19.2 LUBRICATION 50
19.3 TROUBLESHOOTING FLOWCHART 51
19.4 DIAGNOSTIC CODES FOR STATUS LED 52
19.5 FAULT CODE HISTORY 52
19.6 INTERNAL LIGHTING SYSTEM 52
19.7 UV LAMP REPLACEMENT 53
20.0 WIRE DIAGRAM FOR TWO STAGE FURNACE WITH ECM 2.3 / EON 54
21.0 WARRANTY 56
22.0 REPLACEMENT PARTS LIST 57
23.0 SERVICE HISTORY 58
H1.22.1
IMPORTANT
:
PLEASE READ THIS MANUAL CAREFULLY AND KEEP IN A SAFE PLACE FOR FUTURE
REFERENCE BY A SERVICE TECHNICIAN.
ATTENTION
:
TO REMOVE OUTER STAINLESS STEEL DOOR, FIRMLY GRAB DOOR SIDES AND PULL OFF.
TO REPLACE OUTER STAINLESS STEEL DOOR, ALIGN AND PUSH DOOR ON INTO PLACE.
H4.0.6
This high ef fi cient gas fi red two stage condensing furnace is an up fl ow only, warm air furnace suitable for
residential and light commercial heating applications with inputs from 40,000 to 120,000 Btu/hr.
This high ef
fi cient furnace series is CSA certi fi ed as a Category IV indirect or direct vent central forced air
furnace. When installed as a direct vent furnace, all combustion air is supplied to the furnace burners through the
air intake system.
(See Section 7, “Ventilation and Combustion Piping.”)
All models may be fi red by natural or LP gas (propane), and may be fi eld converted from natural gas to LP gas
using Conversion Kit W370-0018.
The furnace is shipped completely assembled except for the condensate drain trap assembly. Please inspect
for damage when the furnace is unpacked.