W415-0721 / 05.06.09
16
2.7 EP65 OPTIONAL BLOWER INSTALLATION
2.8.1
Ensure the thermal disc bracket is in the correct position.
2.8.2
Install the blower and housing as shown using the 4 screws sup-
plied.
2.8.3
Loosen the thermal disc bracket (2 screws) and slide the bracket
until the thermal disc is touching the heat shield and secure.
THERMAL DISC BRACKET
Check that the thermal disc
bracket is positioned
as illustrated.
THERMAL
DISC BRACKET
2
3
SCREWS
BLOWER
2.8 EP90-K OPTIONAL SCREEN KIT
The 1600C-1 may only be operated with the doors open when spark screen
EP90-K is used and installed properly.
This kit is not applicable for mobile homes.
!
WARNING
All wiring should be done by a quali
fi
ed electrician and shall be in compliance with local codes. In
the absence of local codes, use the current CSA22.1 Canadian Electric Code in Canada or the current
National Electric Code ANSI/NFPA No. 70 in the United States.
!
WARNING
Never leave appliance operating unsupervised with spark screen in place.
Use caution when placing this spark screen on an operating appliance.
Turn off the blower before operating with the spark screen.
Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories and replacement parts (blowers, doors, louvres, trims, gas components, vent
components, etc.) could result in a safety hazard and will void the limited lifetime warranty.
