W415-0721 / 05.06.09
15
2.4 ASH FENDER INSTALLATION
2.5 HEAT SHIELD INSTALLATION
To avoid damage during transport, the ash fender has been stored behind the
main door. Pivot the ash fender onto tab “A” and lower into place.
A
The heat shield stored in the appliance must be installed under the appliance
with the 2 provided screws.
2.6 EPRS OPTIONAL REAR SHIELD INSTALLATION
For reduced clearances installation must comply with
NFPA 211 or CAN/CSA-B365.
2.7.1
Remove the 4 screws from the rating plate
on the back of the appliance.
2.7.2
Replace the screws removed with the 4
spacers supplied.
2.7.3
Install the rear heat shield using the 4 screws removed and secure to the 4 spacers. Install the fl ue col-
lar shield to the rear heat shield using the 2 screws supplied.
NOTE: The
fl
ue collar shield is only needed if the
fl
ue collar is in the top exit position. If the
fl
ue
collar is in the rear exit position, the
fl
ue collar shield must be discarded.
1
2
3
HARDWARE INCLUDED:
# QTY. DESCRIPTION
1 2 Screws
2 4 Spacers
1
2