Preparing to Mount the IQ Profiler
1 Insert screwdriver into slot on bottom of unit to remove top of
housing
2 Remove the circuit board from the housing by gently pushing
outward on the PC board height index tab which is located on
the left edge of the housing.
3 Determine the wire entry point to be used. The housing
provides an entry point on the top of the enclosure. Any
unused screw hole recess may also be used for wire entry.
Determine which entry is most convenient and punch out or
remove the thin plastic section.
4 Feed wire through punch out hole.
PC board height
index tab
Swivel mount
punch through
I
nstall
Q
uick
corner mounting slot
Wire entry
punch through
Flat wall mount
screw holes
Standard Corner
mount screw
I
nstall
Q
uick
mounting pins (2)
IQ Profiler base detail
8
Summary of Contents for IQ PROFILER -
Page 14: ...14...
