X
GEM-X255 Programming Instructions
L
NAPCO Security Systems
WI1092B 9/02
!
Page 50
USER PROGRAM MODE
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after
power-up or while any area is armed.
!
After entering codes or data, press the save
J
button. Data will not be stored into memory unless this button is pressed.
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound. Press the
C
button to silence the sounder and exit the User Program Mode.
ACCESSING USER PROGRAM MODE
USER CODES
Up to 195 User Codes may be programmed.
NOTE:
In this mode, only the code is
programmable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 9).
!
Use the
A
button to place the cursor
over the User Number.
!
Enter a User Number (001–195) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
GEM-RP1CAe2 Keypad (Direct Entry)
ENTER USER CODE
001 123___ -_ _ -__
R
COMPUTERIZED SECURITY SYSTEM
GEMINI
ARM
ED ST
ATU
S
SYSTEM ARMED
01/01/97 12:00AM
1 2
4
3
5 6
7 8 9 0
A
B
C
D
E
F
G
NEXT/YES
PRIOR/NO
AREA
# OF ZONES IN AREA 1
ENTER # ZONES X X
ENTER USER CODE
U01 123___ - _1 - __
Us
er Progra
m Mode:
Ac
cessing Program Mode
1. Press
EEEEEE A
2. Press
g
Until
“
ACTIVATE PROGRAM Y/N
”
appears on LCD screen.
3. Press
F
To Enter User Program Mode
4. Press
C
To Exit User Program Mode when finished
!
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G 0
button.
!
Press the
J
button to save the code in memory.
!
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT (
E
) button.
NOTE: All 195 User Codes may be keypad programmed in both User and Dealer program modes.
Programming User Codes
User Code
NOT USED
To Program User Codes
1. Set Cursor Position using
the
A
button.
2. Enter 2-digit User Number
(01-96) directly using
number buttons (0-9).
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
J
button to save
each code.
NOTE:
Press
G 0
button to clear character at cursor.
To continue press
E
or
F
button.
0 0
