• 5 •
5. CHARGING
IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST EVERY 6 MONTHS. Failure to do this will
reduce the battery’s capacity and may void the warranty.
5.1 Connect the micro USB end of the charging cable to the micro USB port on the
side of the work light. Insert the USB end of the cable into the USB port on the
wall charger. Plug the AC charger into a live AC outlet.
5.2 The green charging LED will light, to indicate charging has begun.
5.3 Charging will take approximately 3-4 hours.
5.4 Recharge the work light after use, and at least every 6 months.
6. OPERATING INSTRUCTIONS
6.1 Hang the work light, using the hook on the back.
6.2 The magnets may be used instead. Attach to any ferrous metal surface.
6.3 Direct the lens away from your eyes before turning on the work light.
6.4 Press once to turn on the end SMD LED.
Press a second time to turn on the high-power COB LED.
Press to turn off.
6.5 Recharge the work light after use, and at least every 6 months.
VOTING
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing maintenance, disconnect the work light from
the charger.
7.2 Use a dry cloth to wipe any dirt or oil from the charger, cord and case.
7.3 Any servicing should be performed by qualified service personnel.
8. STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the charger, cord and unit. Failure to do so
could result in personal injury or property damage.
8.3 Charge the work light’s internal battery immediately after purchase, after every
use and every 6 months.
8.4 All batteries are affected by temperature. The ideal storage temperature is at
70°F. The internal battery will gradually self-discharge (lose power) over time,
especially in warm environments. Leaving the battery in a discharged state may
result in permanent battery damage. To ensure satisfactory performance and avoid
permanent damage, charge the internal battery every 6 months.
